Loading…
33
Just realized my level was off by a quarter inch on a 10 floor job
I was doing a routine leveling check on a new install in a downtown Denver building last Tuesday. The car kept drifting slightly to the right every few floors. Turns out my digital level was reading 0.25 degrees off because I dropped it getting it out of the truck. Had to re shim three intermediate landings after I recalibrated it with a known good level from the shop. Has anyone else had a tool go bad on them mid job and mess up the whole alignment?
2 comments
Log in to join the discussion
Log In2 Comments
olivia_anderson5mo ago
Honestly, is a quarter inch really that big of a deal on a 10 floor job? Seems like something that would barely be noticeable.
7
markc845mo ago
I used to think that way too but honestly a quarter inch adds up quick across a whole building.
3