Spent 4 hours chasing a dead network jack that was just a bent pin
Last week a client in Tacoma called about one office jack that would not connect, and I figured it was a 20 minute job. I swapped patch cables, re-terminated both ends twice, and even dragged out the cable tester to check all 8 wires. Turns out one of the pins in the wall keystone was pushed flat, and I only found it when I held a flashlight at the right angle after about 4 hours of head scratching. Worst part is the office manager kept walking by saying the coffee machine was faster than my fix. Has anyone else had a keystone jack die on them like that, or was this just my bad luck?
Bent pins in keystones happen more than people admit, especially on the cheaper ones where the plastic is thin. Now I keep a known good short patch cable in my bag and plug it straight into the jack, then wiggle it a little while watching the link light. If it flickers or drops, the jack is suspect and I just swap the keystone instead of wasting time on the cable ends. A cheap flashlight held low across the pins shows you right away if one is flat or pushed back. Four hours stings but you'll spot it in 5 minutes next time.