A customer's complaint about my domino joints changed my setup
A guy in Des Moines said my loose tenons wobbled after 6 months, said I was relying on the domino too much instead of the glue-up. I swapped to a router sled for all face frames last week, and the fit is dead square every time now. Anyone else have a customer call out a specific joint that made you switch methods?
Did you check the mortise depth on the domino before you bailed on it? A lot of wobble comes from the cutter not being set deep enough, so the tenon bottoms out and the glue starves. I run a test cut on scrap every time I change the height setting and it fixed most of my loose joints. Router sled is a solid call for face frames though, you get a lot more control over the fit.
Depth is part of it but the bigger issue is usually the fence not sitting flat against the reference face. If the board has any cup or twist, the domino registers off that warp and the whole joint pulls out of square even when the mortise is dead on. Checking depth helps, but you also gotta sight down the stock and pick your reference face before the cut. Clamping the workpiece down flat to the bench instead of just holding it also kills a lot of that wobble. Router sled is still the better call for face frames either way.