Picked the in-frame rebuild over a crate motor and the odometer just rolled past 400k
My 2006 Ram 2500 with the 5.9 had 389k on it and the blowby was getting bad enough that the oil cap would dance on the valve cover. I sat on the fence for about 3 weeks between dropping in a reman crate motor for around $6,800 or doing an in-frame kit for about $2,200 in parts. I went with the in-frame since the block and crank still checked out fine, and honestly the scariest part was pulling the pan with the engine still in the truck in my gravel driveway in Amarillo. Took me 4 weekends, a lot of zip ties on the wiring harness, and one snapped exhaust manifold bolt that cost me a whole Saturday with a drill and extractor. Fired it up two weeks ago and it idles smooth with barely any blowby, and I rolled 400,200 miles on the way to get coffee this morning. Still burning a little oil but nothing like before, and I'm watching the dipstick like a hawk for the next 500 miles. Any of you run an in-frame kit this high in mileage and did the rings seat in okay, or am I kidding myself that this thing has another 100k in it?