Showerthought: I swapped my 14in bandsaw blade for a 3/8in skip tooth and my cuts got WORSE, not better
Every forum post I read said a narrower blade is the way to go for curves. So I pulled the 14in blade off my old Delta, put on a 3/8in skip tooth, and spent a Saturday trying some curved cuts on 3/4in oak. The blade wandered so bad my line looked like a drunk snake. Turns out the tension on my machine can't hold a thin blade steady, and nobody mentions that part. Put the wide blade back on and it cut cleaner on the same board. What width do you actually run on an old 14in saw, and did you have to upgrade the guides to make a thin one work?