Built a 2x4 workbench with pocket screws and it racked 3/4 inch by day two
I spent a Saturday building a simple 2x4 workbench for my garage in Fresno, and I was pretty proud of how square it looked when I set it down. Two days later the whole thing had racked about 3/4 inch, enough that my miter saw sled started rocking on it. Turns out I skipped the corner braces and just trusted the pocket screws to hold everything, which was a mistake on a 6-foot span. I added 45-degree braces on the back and sides, and it has not moved since. Any of you run into racking on your first bench, and did you go with braces or a full sheet of plywood on the back to stiffen it up?