Blew out my rear tube twice in one afternoon and I think I finally get what I was doing wrong
Saturday started fine. I pulled my bike off the wall hook to swap the worn rear tire before a longer ride Sunday, and things went south from there. First tube pinched when I put the tire back on with a set of plastic levers I have had for years. Fine, grabbed my last spare, put it in, and it held air till I leaned on the pump hard and the valve stem tore right at the rim. Two tubes, 40 minutes gone, and I was sitting on the garage floor getting mad at a bicycle.
The thing I think I learned is that I was rushing the last bit of the tire bead. Once it pops on that last few inches, I need to slow down and check the tube is not stuck under the bead before I air it up. Second thing, I have been using a floor pump with a loose head that twists the valve, and I bet that is what killed the second tube.
So before I buy more tubes this week, what is the actual trick you all use for that last stretch of bead? Levers or thumbs? And does anyone run a different pump head to stop the valve twisting? I would rather fix my method than keep feeding the tube money pile.