Took me 3 whole shifts to track down a 0.003 inch taper on a shaft job
Last week I ran a batch of 4340 shafts for a hydraulic shop over in Rockford and the last op kept coming out with a tiny taper, about three thousandths over 8 inches, close enough to pass but it bugged me. I checked the tailstock, re-indicated the chuck twice, swapped the center, and even pulled the program apart line by line thinking I fat fingered a feed. Spent most of shift two on it and got nowhere. Turned out the coolant nozzle was aimed right at the back of the part and the thermal growth from warm coolant on one side was doing it, I moved the hose and the taper dropped to under a thousandth on the next three pieces. Felt dumb and relieved at the same time. Three shifts for one hose. Any of you ever chase a size problem that turned out to be heat and not geometry?