Spent $80 on a dovetail jig and my hand cut joints still look better
I picked up a dovetail jig last month for a cedar chest project and figured it would save me hours. After fighting with the setup for two evenings and burning through three test boards, the joints came out loose on one side and too tight on the other, and I ended up recutting half of them by hand anyway. The part nobody says out loud is that a jig only works if your stock is perfectly milled, and my bargain cedar was anything but flat. So now the jig sits on a shelf and I'm back to my marking gauge and a $25 Japanese saw, which is slower but at least I know what I'm getting. Has anyone found a jig that actually handles less than perfect lumber, or am I just buying into the wrong tool?