My shop vac ate a whole box of trim screws and I spent 20 minutes cutting the thing open
So last Tuesday I was wrapping up a small closet job in a house over in Chandler and I had this half-empty box of 1 5/8 inch trim screws sitting on the floor next to my miter saw stand. I bumped the hose with my knee, the box tipped right into the vacuum nozzle, and it sounded like a maraca full of gravel for about two seconds before it choked out and died. I know I should have just dumped it and dug the screws out of the drum, but I panicked and thought the motor was burning up so I grabbed my utility knife and sliced the hose off at the base. That was dumb, because the screws were all jammed in the elbow joint and now I've got a $70 shop vac with a hose that's about a foot shorter and some duct tape doing the holding. The worst part is my helper picked up the box and counted 34 screws still scattered on the drop cloth, so I mutilated a perfectly good vacuum over basically nothing. Has anybody got a smart way to keep small hardware from falling into the hose, because clearly my system of "just leave it on the floor" is not working.